STEL Range Agitated Pressure Pots User Guide

Alarm list

*1 When using the alarm reset on the monitor mode or resetting the alarm by assigning the ALARM- RESET input to the input to the terminal *2 If a load exceeding the limited duty region was applied or the output shaft was locked, an alarm is generated in maximum 5 seconds. However, if the value of the “overload alarm detection time except when holding a shaft” parameter is set to 5 seconds or less, the overload alarm is generated in the time that was set. *3 This alarm is output when the “prevention of operation at power-on alarm” parameter is set to “Enable”. Refer to page parameter list for setting whether to enable or disable the “prevention of operation at power-on alarm” parameter. *4 This alarm is output when the EXT-ERROR is assigned to input terminal.

page 69