STEL Range Agitated Pressure Pots User Guide

g. Connecting the power supply

Connect the power cable to the CN1 on the driver. The power cable is not included. It is provided as an accessory.

Be sure to connect a circuit breaker to the power line of the driver to protect the primary circuit. Rated current of protective device: Single-phase input 10A, three-phase input 10A. Recommended circuit breaker: Mitsubishi Electric Corporation NF30

Connecting the I/O signals on the 1,2 and 5L Driver Connect the I/O signals to CN4 on the driver.

Connecting the lead wire

- Applicable lead wire: AWG26 to 20 (0.14 to 0.5mm3) - Length of the insulation cover which can be peeled: 8mm

CN4 Pin assignment

The signal in brackets [ ] is a function that is assigned at the time of shipment. The assigned functions can be changed by setting parameters. Refer to page … for details.

page 53