STEL Range Agitated Pressure Pots User Guide

There are two possible ways of installing the driver. Either directly mounted on a flat surface or using the bracket supplied with the driver.

If installing the driver to a flat metal plate. Make sure the surface offers excellent vibration resistance.

Remove the front panel of the driver and secure the two mounting holes using screws and nuts (M4 or No.8-32UNC: not supplied). Tighten the screws until no gaps remain between the driver and mounting plate.

 The space between the mounting hole section and front panel of the driver is 6mm. Therefore, the total height of the screw head and washer should be less than 6mm. The front panel cannot be installed if it is exceeded 6mm.  If the washer is used, use the washer which outer diameter is 10mm or less.

page 48