ADL-DISP5600-User-Guide-24

ADL-DISP5600 Digital Air Free Dispenser

ADL-DISP5600

OPERATING MANUAL

11.0 CAUTIONS & REMINDERS • Use the nominal Voltage (AC 220V/110V, 50/60Hz) • Do not remove the body cover. • Do not modify the body or any of its interior parts. • Do not touch the pump, rolling parts and the rotor’s inner parts while the pump is working under electric power. • Do not place objects into the nozzle. It may cause a crack in the tube or a liquid leak. If the inner rotor is stuck with liquids, send immediately back for quoted repair. • Do not place any heavy objects on the case. • The case should be placed on a working desk with a flat surface. Avoid falling or dropping. • When moving the case, hold firmly with both hands. • Do not use unspecified PTFE or Silicone tubes for the roller. • The power socket-outlet shall be installed near the equipment and shall be easily accessible. • If the equipment is used in a manner not specified by the manufacturer, the warranty may be invalid. • When installing the controller, please be careful not to prevent the ventilating openings on the side of controller being blocked. Good ventila tion required. • Please be sure to turn off power when you plug the finger switch to the controller.

11.1. Environmental conditions for the equipment operation • Indoor use only. • Altitude up to 2000 m • Temperature - 5 ℃ to +50 ℃ . • Maximum relative humidity 80% • Mains supply voltage fluctuations not to exceed ±10 % of the nominal voltage. • Transient over voltage according to INSTALLATION CATEGORIES (OVERVOLTAGE CATEGORIES) II • POLLUTION DEGREE 2 in accordance with IEC 664

© 2024 Adhesive Dispensing Ltd.

www.adhesivedispensing.co.uk

sales@adhesivedispensing.co.uk

+44 (0) 1908 686660