ADL-DISP5600-User-Guide-24

ADL-DISP5600 Digital Air Free Dispenser

ADL-DISP5600

OPERATING MANUAL

7.0 OPERATION GUIDE • Put the plug into the outlet. Turn the power on • Set the tube onto the metal roller (please refer to figure #3). • Set the direction mode and operation mode. ① Liquid flowing direction; CW: Reverse * CCW: Forward ② Operation mode; * ANGLE: One Circle * STEADY: Manual * CONT: For continuous use. • Set negative pressure / interval times according to your operation. • Press Finger/Foot S/W to start operation. Set the Tube:

• As shown in the right picture, pull closure rod out to loosen bolt and release clamp. • Put the tube into the right groove of steady and set around roller. • Put the rest of the tube around the roller and into the lower steady. Screw the nuts to secure.

• After setting the tube, turn the roller around a couple of times manually to allow the tube-flexible movements.

Slowly close the TUBE GUIDE while turning the rotor. Secure the TUBE GUIDE by pulling the GUIDE LOCK in the upward direction. If you are inserting a thick tube and the rotor stops, start over. If the TUBE GUIDE is tightened without turning the rotor, the shape of the rotor will be impressed on the tube and the tube will not be inserted evenly. Always turn the rotor while closing the TUBE GUIDE. Lift the TUBE HOLDERS to support the tube at both ends. Secure the TUBE HOLDERS using the LOCKING KNOBS. Cut the end of the tube as shown to make insertion into nozzle easier.

Pass the tube through the nozzle holder, then through the nozzle. Pull out the exposed section of the tube with pliers or other tool. Insert the nozzle into the holder. Cut the end of the exposed tube as shown.

Insert material tube other end into adhesive bottle.

www.adhesivedispensing.co.uk

sales@adhesivedispensing.co.uk

+44 (0) 1908 686660