XYZ robot program manual AD300N

3.3.4 Path Planning

3.3.4.1 Set Basic Point

“Basic point” here means points used only for home adjust of process files. During

actual processing, as changes of workpiece position and work drum may both cause

deviations of storage route.

Click

” of tool bar, there is reminder” please specify home reference”, then

click the position of basic point, after setup, command window shows information. Basic

point already set up shows in screen via”

”.

3.3.4.2 Sorting Of Route

Logoshop has function of automatic sort, you just need to specify a reference position,

Logoshop would sort sequence of graphics automatically, if necessary, automatic sort could

reduce move route via changing direction of graphics.” automatic sort” starts from specified

reference position and find the nearest graphics, until finish sorting all graphics.” automatic

sort” can make sure optimization of part route.

When clicking button”

”, initial reference position is start point before sorting,

that is position of ” button, the sorting goal is all graphics in drawing table.

When clicking button”

” again, Logoshop would reminds of you reference

sorting point, you may key in values you like via mouse or key board.

3.3.5 Set Graphic Parameter

Except parameters of “file default parameter”, each graphics can be set up craft

parameters independently. After setting up parameters, when exporting, it will use graphics

parameters, if no, it will use parameters of “file default parameter”.

“Graphics parameters” is located in right side of main interface of Logoshop, you may

refer to below picture.

40