TS2220 TS2250 TS22100 TS2216 User Guide 26

USE AND MAINTENANCE MANUAL

Assigned

Description

Frequency

Chapter

Every component start-up or end of work Every component start-up or end of work Every component start-up or end of work Every component start-up or end of work

Perform superficial valve cleaning

\

Perform fluid system leak check

\

Perform pneumatic system leak check

\

Perform cover seal tightness check

\

Safety valve check

Quarterly

\

When necessary

Cover gasket replacement

\

It is recommended to keep a table with all maintenance performed for each tank.

ATTENTION! For component cleaning do not use aggressive products or those that can react either with tank materials or with the fluid being used. For safety valve checking, the pressure inside the tank must be brought slightly above that indicated in Chapter 2.2 and the safety valve should be heard venting; afterwards, the pressure inside the tank can be returned to working pressure.

For gasket replacement, follow the following table, based on the component purchased:

TS2220 -> PT-2-GASKET; TS2250 -> PT-5-GASKET; TS22100 -> PT-10-GASKET; TS22 16 -> PT-16-GASKET.

• • • •

Furthermore, all gaskets are in NBR, unless different agreements with the manufacturer. In this case, contact the manufacturer directly..

ADHESIVE DISPENSING LTD

COD.: DTVI_PT_2447 REV.: 02 DATE: 10/02/2026

EN

Any reproduction (total or partial) of this document noaut thorizedby the manufacturer will be punished according to the law.

24