TS2220 TS2250 TS22100 TS2216 User Guide 26

USE AND MAINTENANCE MANUAL

5.2.2 Pneumatic

PPE to wear

Authorized personnel

Component State

Component placed in the work zone

Supply Values

See chapter 2.2

Required Preparations Required Material Required Equipment

Functioning air pneumatic system

Pneumatic connection is the customer's responsibility.

For the component pneumatic system connection, it is necessary to have a Ø6X4mm tube and connect it to the pressure reducer placed on the component cover. To connect it, simply apply some pressure by pushing the tube inside the hole until hearing a connection confirmation sound.

ATTENTION! There is a risk of tube disconnection from its connection area if it is not inserted properly. Before activating air, perform a tube seal test by pulling lightly.

5.2.3 Fluidic

PPE to wear

Authorized personnel

Component State

Component placed in the work zone

Supply Values

See chapter 2.2

Required Preparations Required Material Required Equipment

N.A. N.A. N.A.

Fluid connection is the customer's responsibility

Generally the fluid tube can be either Ø6X4 or Ø8X6, based on applications and the type of fluid to be worked with. This tube enters through an appropriate fitting and must reach almost to the bottom of the tank. Once inserted, the fitting that clamps the tube and keeps it locked in position must be screwed. If inserting a new tube, first unscrew the block that holds the tube in position, remove the old tube, insert the new tube being careful that it stays a few centimeters from the tank bottom, cut the measurement at 45° so that the tube has even more difficulty adhering, insert the tube and screw the block, so that the tube stays in position. ATTENTION! The tube must not be tightened too much otherwise there is a risk of breaking it or choking it too much, affecting the dosing quality.

ADHESIVE DISPENSING LTD

COD.: DTVI_PT_2447 REV.: 02 DATE: 10/02/2026

EN

Any reproduction (total or partial) of this document noaut thorizedby the manufacturer will be punished according to the law.

18