DB50 Adhesive Debonder Liquid SDS

MATERIAL SAFETY DATA SHEET Cyanoacrylate/ Adhesive DeBonder Remover DB50

7. HANDLINGAND STORAGE Handling:

Avoid direct contact with the substance. Ensure there is sufficient ventilation in the area. Avoid the formation or spread of mists in the air. Prevent contact with water. Store in cool, well ‐ ventilated area. Keep container in tightly closed in original packaging.

Storage conditions:

8. EXPOSURECONTROLS/ PERSONALPROTECTION

Engineering controls:

Use local ventilation if general ventilation is insufficient to maintain

vapor concentration below established exposure limits.

Respiratory protection:

Use a NIOSH approved respirator if there is potential to exceed exposure limit(s).

Skin protection:

Chemical resistant, impermeable Safety goggles or safety glasses with

gloves. Eye/face protection:

side shields. See Section 2 for exposure limits. 9.

PHYSICALAND CHEMICALPROPERTIES

Physical state:

Liquid Slight

Odour:

Vapour pressure:

<0.02kPa @20°C Not applicable Approximately 80°C Not available

pH:

Boiling point/range: Melting point/range: Specific gravity: Vapor density: Evaporation rate: Solubility in water:

0.78

Heavier than air Not available Immiscible

Partition coefficient (n ‐ octanol/water):

Not available

10.

STABILITY AND REACTIVITY

Stability:

Stable.

Hazardous polymerization: Hazardous decomposition products:

Will not occur.

No data available

Incompatibility: Conditions to avoid:

Acids. Oxidizing agents. Heat, flames and sparks.

1.

TOXICOLOGICAL INFORMATION

Hazardous ingredients

Propylene Carbonate ORL MUS LD50 20700 mg/kg ORL RAT LD50 29100 ul/kg

Tel +44 (0) 1908 686660 Fax +44 (0) 1908 686836

Unit 55 Alston Drive Bradwell Abbey Milton Keynes, MK13 9HB United Kingdom

Adhesive Dispensing Ltd Sales & Service Freephone 0800 094 9058

Registered in England & Wales Reg. No 6048283 VAT No. 901 8594 21

info@adhesivedispensers.co.uk www.adhesivedispensers.co.uk