Cyanoacrylate Adhesives Technical Data Sheet 2026

General usage instructions

1. Ensure surfaces are clean, dry and free from dust, oil, grease or release agent. 2. Select the adhesive viscosity to suit the joint fi t, substrate type and required placement control. 3. Apply a minimal amount of adhesive to one surface. Excess adhesive can slow cure and reduce appearance quality. 4. Assemble parts immediately and hold in position until handling strength is achieved. 5. Use activator where rapid cure is required, where the bond line is exposed, or where di Ư icult substrates require assistance. 6. Use primer where bonding low-energy or di Ư icult substrates and verify performance through production trials. 7. Refer to the relevant Technical Data Sheet and Material Safety Data Sheet before use. Storage, safety and customer notes Keep containers sealed when not in use and store in accordance with the product label, Technical Data Sheet and Material Safety Data Sheet. Always test adhesive, activator and primer combinations on production materials before release to production. Values shown are typical website-listed data and are intended as a customer selection guide; fi nal suitability depends on substrate, surface preparation, joint design, production environment and dispensing method.