ADL-300 Rotary Table User Guide 24

ADL-300 Overview

19

20

9

3

1

2

18

7

17

16

D

R

6

5

10 11

8

15

Overview (assuming round jig plate has been created and placed on machine spindle). 1. Connect mains power, air hose pipe, footswitch into rear or ADL-300. 2. Connect syringe barrel adapter assembly tube into rear of ADL-300. 3. Adjust the height of the main gantry bracket to upright steel rod. 2 nuts to loosen and move up/down to suit. 4. Adjust the nut that secures the syringe bracket bar to set the angle and width 5. Press power switch on. 6. Adjust air pressure to 0.2MPa (to start as can be increased/ decreased when required).

7. Load product to the spindle on customers own jig plate. 8. Press Z index switch to move the head to down position. 9. Place syringe barrel with tip into the clamp and tighten. The tip should be within 1mm to the substrate of part. Flick the Z direction switch (8) to index the head back into home position. 10. Press the select button (10) so the icon flashes at the ‘dispense time’ (D). 11. Press the up button to adjust dispense/ spin time. 12. Press select button (10) to move the icon to RPM “R”. Set to suit spin speed required up to 300RPM. 13. Press the select button (10) so that icon moves to the ‘start delay’ (SD) speed. Increase so that the time at which point where dispensing starts after the spindle spins. 14. Press the select button (10) so that the icon moves to the ‘end delay’ (ED) speed. Increase so that the time at which point where dispensing ends as the spindle is spinning. 15. Adjust air pressure to suit. Increase for faster flow rates, reduce if too rapid. By combining spin speed and air pressure, you can set the right speeds to suit.

16. Use vacuum suck-back to reduce drips. 17. Press footswitch or start button to run. 18. Press stop button if required.

19. Adjust valve on Z movement to increase/ reduce down speed. 20. Adjust valve on Z movement to increase/ reduce up speed.

21. Make adjustments to spin speed, air pressure to syringe barrel, tip diameter, etc. to suit application. 22. Contact us for advice, support, spares or accessories to discuss the application and any questions.

www.adhesivedispensing.co.uk sales@adhesivedispensing.co.uk +44 (0) 1908 686660