AD1001 Digital Timed Shot Dispenser UG 2024

AD1001 DIGITAL TIMED DISPENSER

AD1001

OPERATING MANUAL

6.0 MODES 3. Press the SET key 9 times to get to memory address 9.

4. Press the EXIT/MODE key to complete the save. To save your current cycle mode settings switch the mode to cycle and then continue with the above procedure. Loading from Memory After saving your Cycle Mode and Timer Mode settings to the AD1001 memory you can then recall them to be used again. Both the Cycle Mode and Timer Mode need to be loaded separately by switching to the mode you would like to load. For Example : To load the time (dispense time I second) that was saved in memory 9 on the previous page fol low the below steps.

1. Press Mode button, Switch to Time Mode, the display will show 01.00.

2. Press SET button three times, the third digit on the right side of the display will start blinking.

3. Press the SHOT button to adjust the digit to 0.

4. Press the EXIT/MODE key to complete the load. Program 9 Time Mode settings are now out of effect. To load the cycle mode settings switch to circle Mode then follow the same directions.

www.adhesivedispensing.co.uk

sales@adhesivedispensing.co.uk

+44 (0) 1908 686660