AD-Series-Robots-Hardware-User-Guide

6. TROUBLE SHOOTING 1. The System cannot Reset after Booting.

Emergency switch error

 Check the Emergency switch is not pressed, by mistake. This sounds a continuous beep.

2. Z axis or X and Y axis cannot be PositionedAccurately in Processing

1) Loss of phenomenon. Overload, excessive speed or acceleration, insufficient power supply, or mismatched motor drive would lead to the loss of steps. Please check the overload and the parameters settings. If the inaccurate positioning phenomenon disappears or remits after reducing the speed or acceleration, we can make sure the phenomenon is caused by the motor loss of steps. If inaccurate positioning phenomenon is very obvious for one axis, reduce the acceleration of the axis. 2) Operation Error will cause inaccurate positioning phenomenon. Do not reset when the work done Make the system reset automatically after each accumulated processing error has been eliminated,) Manufacturer warrants this product to the original purchaser for a period of one (1) year from date of purchase to be free from defects in material and workmanship, but not against damages by misuse, negligence, accident, faulty installations and instructions. Manufacturer will repair or replace (at factory’s option), free of charge, any component of the equipment thus found to be defective, on return of the component, “PREPAID” to the factory during the warranty period. In no event shall any liability or obligation of the Manufacturer arising from this warranty exceed the purchase price of the equipment. This warranty is only valid if the defective product is returned as a complete assembly without physical damage. The Manufacturer’s liability, as stated herein, cannot be altered or enlarged except by a written statement signed by an officer of the company. In no event shall the Manufacturer be liable for consequential or incidental damages. A return authorization is required from Adhesive Dispensing Ltd prior to shipping a defective unit to the factory. steps will cause inaccurate positioning 7. WARRANTY

Manufacturer reserves the right to make engineering product modifications without notice.

All returns must be issued with a Returns Authorization number, prior to return. Send warranty returns to:

Adhesive Dispensing Limited, 55 Alston Drive. Milton Keynes, MK13 9HB, UK.

Tel: 01908 686660, Fax: 01908 686660 E-mail: sales@adhesivedispensing.co.uk

Support: technical@adhesivedispensers.co.uk

22