1000T User Guide

Setting Up

Attach syringe barrel:

Fill a syringe barrel with fluid Use a tip cap to seal the tip end. Fill to approx. 2/3 of the barrel. Insert a white, blue or red piston. Push down on the piston so it sits on the liquid. Select a dispensing tip from the assortment sup- plied. Use standard precision tips for most fluids. Use tapered tips for thick pastes. Use Teflon tips for Cyanoacrylates. Use long Polypro tips for pot- ting into products. Select small bore tip for small deposits, larger bore for more output. All tips attach to the barrel by twisting on (luer lock). 1. When the display shows as 0.000, it is set on con- tinuous mode/ teach mode. By pressing the foot pedal in this mode, the dispenser will run so long as the pe- dal remains pressed. It will stop as soon as the pedal is released. Once the pedal is pressed, the timer display will count. So for use as teach mode, see the timer dis- play once its completed as a guide to adjusting the buttons. How to setup dispense time:

To manually set the timer, use the buttons below the LED display to set. Use lower time setting for micro dots. The smaller the time setting and lower the air pressure - the smaller the dot size. By slowly in- creasing timer duration and air pressure, the dot size of glue will increase. There is a vacuum knob. Turn anti-clockwise to increase the air that is pulled against the sy- ringe. This feature is used to eliminate low vis- cosity liquids that might drip. Do not use exces- sive vacuum as it can draw liquid into the dis- penser if a piston is not used. As you use vacuum, air will escape from the rear of the dispenser. Most fluids do not require ex- cessive vacuum is using a piston.

7

adhesivedispensers.co.uk sales@adhesivedispensers.co.uk T. +44 (0) 1908 686660